The Xsafe fixed gas detection system has been specifically designed to meet your requirements. The dangers presented by toxic and flammable gases as well as oxygen deficiency vary with each application.
Xsafe is a non-certified low cost catalytic bead type gas detection system with 3-wire 4-20mA or mV bridge output.
||156 x 166 x 111mm (6.1 x 6.5 x 4.3 inches)
||1 x M20, 1/2 “NPT or 3/4 NPT* on right-side
||0.5 to 2.5mm2
||mV: -40 to +80°C (-40 to 176°F)
mA: -40 to +55°C (-40 to 131°F)
||-25°C to +65°C (-13°F to +149°F)
||10 to 95% RH
|Repeatability Zero drift
||<2% FSD (Typical)
<2% FSD per Month (Typical)
||T90 <15s (Typical)
||mA: 10-30V dc
mV: 2.0V dc
||mA: 50mA at 24V dc 1.2W
mV: 300mA (Typical)
||mA: 3- wire 4-20mA (current sink or source)
mV: 3- wire mV bridge
Typical signal: 12-15mV/ %LEL CH4
||Not certified for use in hazardous environments
Safe area only
FCC Part 15
*3/4 ” cable entry only available on aluminium juntion boxes.
Below is a small selection of the accessories available for the Xsafe.
For outdoor installations and protection from water sprays, for example in water treatment or food processing plants. Includes accessory adaptor. (Not suitable for use with Xgard Type 4)
Protects against excessive heat build-up due to direct sunlight.
Supplied with fixing rivets.
For aiding detection of light gases such as methane. 38cm/15″ Dia. Includes accessory adaptor.
For offshore or other extremely wet environments. Includes accessory adaptor. (Not suitable for use with Xgard Type 4)
For use where a gas sample is being piped to the detector.
To enable calibration gas to be applied to the detector. One adaptor can be used for several detectors.
Duct mounting kit
Allows sampling within tubes and ducts. Stainless steel plate with 6mm remote calibration fitting. Maximum duct airflow: 6 metres per second. (Not compatible with Stainless Steel Xgard or Xgard Type 4.)