Xsafe

Compare

Overview

The Xgard range of gas detectors has been specifically designed to meet your requirements. The dangers presented by toxic and flammable gases as well as oxygen deficiency vary with each application.

Xsafe is a non-certified low cost catalytic bead type detector with 3-wire 4-20mA or mV bridge output.

Specifications

Size 156 x 166 x 111mm (6.1 x 6.5 x 4.3 inches)
Weight 1kg (2.2lbs)
Enclosure material Aluminium
Ingress protection IP65
Cable entries 1 x M20, 1/2 “NPT or 3/4 NPT* on right-side
Terminations 0.5 to 2.5mm2
Sensor type Catalytic bead
Operating temperature mV: -40 to +80°C (-40 to 176°F)
mA: -40 to +55°C (-40 to 131°F)
Storage -25°C to +65°C (-13°F to +149°F)
Humidity 10 to 95% RH
Repeatability Zero drift <2% FSD (Typical)
<2% FSD per Month (Typical)
Response time T90 <15s (Typical)
OPerating voltage mA: 10-30V dc
mV: 2.0V dc
Power requirements mA: 50mA at 24V dc 1.2W
mV: 300mA (Typical)
Electrical output mA: 3- wire 4-20mA (current sink or source)
mV: 3- wire mV bridge
Typical signal: 12-15mV/ %LEL CH4
Approvals Not certified for use in hazardous environments

Safe area only

EMC compliance EN 50270
FCC Part 15
ICES- 003

*3/4 ” cable entry only available on aluminium juntion boxes.

Accessories

Below is a small selection of the accessories available for the Xsafe.

Spray deflector

C01052

For outdoor installations and protection from water sprays, for example in water treatment or food processing plants. Includes accessory adaptor. (Not suitable for use with Xgard Type 4)

Sun shield

C011063

Protects against excessive heat build-up due to direct sunlight.
Supplied with fixing rivets.

Collector Cone

C01051

For aiding detection of light gases such as methane. 38cm/15″ Dia. Includes accessory adaptor.

Weatherproof cap

C01442

For offshore or other extremely wet environments. Includes accessory adaptor. (Not suitable for use with Xgard Type 4)

Flow adaptor

C01339

For use where a gas sample is being piped to the detector.

Calibration adaptor

C03005

To enable calibration gas to be applied to the detector. One adaptor can be used for several detectors.

Duct mounting kit

S011918

Allows sampling within tubes and ducts. Stainless steel plate with 6mm remote calibration fitting. Maximum duct airflow: 6 metres per second. (Not compatible with Stainless Steel Xgard or Xgard Type 4.)

Downloads

Datasheet

Manual